Measurement & technical drawing
What measurement & technical drawing means
Read measurements and interpret basic technical drawings.
Before you start
Not confident yet? Work through Workshop health & safety first.
Worked example
One question from this skill's own question bank, shown with its full working.
How many millimetres are in 2.5 centimetres?
- 0.25 mm
- 25 mm
- 250 mm
- 2.5 mm
Working: 1 cm = 10 mm, so 2.5 cm = 25 mm.
Curriculum and exam alignment
Curriculum notes are a general guide to where this work normally sits. Always check the syllabus your school or examination body is currently using.
Related skills
Other TVET Foundations skills in TVET & Trade Skills, at the same point in the course.
Other TVET & Trade Skills topics
Related study guides
Core Maths is compulsory and it fails more WASSCE candidates than any other paper. This guide breaks…
Dreaming of a US university with a scholarship? The SAT or ACT is your gateway. This guide explains …
Exams that assess measurement & technical drawing
Senior High work on this skill feeds directly into these exam papers. Each page lists the TVET & Trade Skills topics that appear on it.
How this page was produced
This text was drafted with AI assistance from the questions and topics already stored on the platform. A subject-specialist review is scheduled but has not yet been recorded, so we do not claim it here.
- Written by
- DigiTransact Mastermind editorial team
- Human review
- Not yet. Subject-specialist review is scheduled; this page will say so once it has happened. See which content receives human review.
Spotted a mistake on this page? Report a content correction and we will check it against the source. You can also read our editorial policy and how we use AI and where it falls short.
Practise measurement & technical drawing
8 questions with a worked answer after every attempt, and a SmartScore that tracks how close you are to mastery.